Three numbers. That's it.

Width, height, and depth — measured from the right places. Get these right and your panels fit the first time.

Width

Screen wall, left to right

Height

Floor surface to ceiling

Depth

Screen wall back to player

Measurement	How to measure	Designer field
Width	Screen wall, corner to corner, at floor level	Screen width
Height	Top of flooring surface to ceiling — measure left, center, right; use the smallest	Screen height
Depth	Screen wall back along side wall to player area	Bay depth

Important

Measure height from the top of your flooring

Not the subfloor. Turf and pad add ¾"–1½" of height. If you measure from bare concrete and install turf later, your panels will be too tall and buckle.

Measure from the green line (top of turf), not the subfloor beneath it.

No turf yet? Measure the subfloor, then subtract your planned turf thickness. A safe estimate is 1" total (½" pad + ½" turf). Already installed? Just measure from the top of the fiber.

Before you submit

Note obstacles

For each outlet, switch, window, or vent: measure its height from the floor, distance from the nearest corner, and its width × height. Take photos. We'll cut panels to fit around them.

Walls aren't perfectly square. Measure height at the left, center, and right. Use the smallest value so panels fit everywhere.

Send us your numbers

Format: Width × Height × Depth (e.g., 12' × 9' × 10')
Note your flooring type and thickness. List obstacles with photos.

Launch Panel Designer → Get a Quote 📞 (402) 281-3451